ZOLL M Series Defibrillator Capacitor 9126-0006
ZOLL M Series Defibrillator High Voltage Energy Discharge Capacitor
Capacity 9126-0006 QL232EW115V23A
► Brief Description
ZOLL M Series Defibrillator High Voltage Capacitor 9126-0006
Zoll M Series Defibrillator Capacitor 9126-0006 - This is an
important part of the Zoll M series defibrillator. Its main role is
to store energy, which can provide the high energy pulse required
for the defibrillation operation. The second role is to provide a
stable output to ensure the stability of the defibrillation pulse.
The third function is rapid discharge, which can complete the
discharge process in a very short time and achieve instantaneous
high energy output. This rapid discharge property is essential for
timely termination of the abnormal rhythm.
► Removing
Tools Needed
• Number two screwdriver
• Cutting knife
• Polyester tape
Step ahead
1. Remove the front panel assembly.
2. Remove the House of Lords.
3. Remove the system board.
4. Remove the battery connection plate.
5. Remove the high voltage charger assembly.
6. Lift up the capacitor assembly from the chassis. (The capacitor
assembly is still connected to the high voltage module assembly.)
Step 1: Open the high-voltage capacitive plastic isolator and lift
the polyester tape.
Step 2: Excess voltage is released using a resistor with a value of
about 5 millimetres, 25 watts, for 10-20 seconds. Measure the
voltage on the capacitor terminal.
Step 3: Disconnect the inductor and capacitor terminal wires when
the capacitor voltage is 0 VDC.
► More Details
ZOLL M Series Defibrillator Capacitor 9126-0006 sometimes needs to
be replaced, the following are some situations that need to be
replaced:
| 1. Press the charge button, can not charge; |
| 2. The capacitor voltage is too high to meet the selected energy; |
| 3. Capacitor voltage > absolute rated maximum value; |
| 4. Unable to charge defib cap; |
| 5. Defibrillators charge too slowly; |
| 6. 4 defibrillators malfunction detected within 20 seconds; |
| 7. Discharge switch in undefined state; |
| 7. Discharge switch in undefined state; |
| 9. The VMON voltage during charging is less than the target energy; |
| 10. When the defibrillator is charged or ready, the capacitor
voltage of the defibrillator is greater than the selected energy; |
| 11. The voltage of the defibrillation capacitor has exceeded the
absolute maximum acceptable voltage; |
| 12. Defibrillation capacitor voltage does not decrease; |
| 13. The flyback pulse width control circuit is not properly
controlled by the processor and gate array. |
If you have these problems with your Zoll M Series defibrillator,
there may be a problem with the high voltage capacitor, which can
be solved by trying to replace the high voltage capacitor.
Thanks for your interest in ZOLL M Series Defibrillator High Voltage Energy Discharge Capacitor
Capacity 9126-0006 QL232EW115V23A, please feel free to contact me. Thank you for your time and wish
you have a happy life.
